The poor working environment in Epoxy has a great impact on the life span of Eruption. Large wear and tear, frequent repairs and replacement of wearing parts are undoubtedly a big investment for users. So how to reduce this investment? Jaw crusher thrust plate is mostly made of cast iron material, thrust plate seat is mostly cast steel or cast iron parts, thrust plate plays a role in the transmission of motion and force, but also plays a role in safety protection and to adjust the ore the size of. Because the thrust plate is installed in the lower part of the machine body, it is not easy to maintain. Therefore, the plate head and the plate seat are the most easily worn parts. The worn plate and head can be repaired after surfacing welding, spraying, and brush plating. When the thrust plate breaks, due to the function, it is generally not repaired and the new thrust plate should be replaced. However, the combined thrust plate can be removed and used continuously.

There is daily, we must do a good job of jaw crusher maintenance work, often check the wear of various parts, add lubricants and so on. And timely detection of problems, timely maintenance can extend the life of equipment, saving equipment investment. In addition, when the E-breaker is working, the vibration is very large. When it is working for a long time, it will be fretting and worn. The screw will slide and the screw hole will be worn. The through-hole will be worn, such as the anchor hole, the bearing screw hole and the spring pull rod machine. Support holes and so on. After these holes are worn out, besides the welding repair, bolt holes can be added to the pad or the screw diameter can be increased to replace the bolt.