First, the three fine motorized valve does not work after power Check the power supply connection is not good → re-wiring and connector connection Check the power supply voltage is within the scope of work → → tune the normal position of the coil is not desoldering → re-welding coil short circuit → replace the coil Working pressure difference is not appropriate → adjust the pressure difference → or replace the appropriate electric valve fluid temperature is too high → replace the electrically-driven valve is equivalent to the impurities so that the main valve core and the moving core stuck → cleaning, seal damage Should replace the seal and install the filter Liquid viscosity is too high, the frequency is too high and life has been to → replace the product Second, the electric valve can not close the main spool or iron core seal has been damaged → Change the seal fluid temperature, viscosity is too High → replace the electric valve counterparts have impurities into the valve to produce electric valve or moving core → cleaning spring has reached or deformed life → replace the orifice balance hole blocked → promptly clean the working frequency is too high or life has been to → re-election of products Or update the product Third, the other leaks → Check the seal is damaged, the spring assembly is not good External leakage → Loose connections or seals have been → screws or fasteners replace the head of the noise → loosening the seal is energized, tighten. Voltage fluctuation is not within the allowable range, adjust the voltage. Core suction surface impurities or uneven, timely cleaning or replacement. This article Keywords: electric valve
Computerized horizontal cutting machine is mostly used for shearing sponge block. Electronic control cutter can
hold up and down, sending cutter and platform back and forth. Pressure shaft device
ensures the stability of cutting. Auto shearing and picking up make the operation simple. It
is the best equipment of high quality and efficiency. (Suction is optional)
Manual vertical foam cutting blade is mainly used to cut the large foam into the same length, pieces and slices.
As well as for further process of different specifications of small foam, bidirection cutting can
be choose