CS cone crusher introduction:

CS Series High-efficiency Spring Cone Crusher concentrates on the specialty of high-frequency, optimization of cavity and reasonable impact. It is based on the conceptions of laminated crushing principle and more crushing and less grinding. It is researched and designed by our company, according to the customers` requirement. This CS series cone crusher is widely used to crush metalliferous and non-metalliferous ores, cement, construction and sand. The materials can be iron stone, non-ferrou metal ore, granite, limestone, quartzite, sandstone, cobble , etc

Working principle of CS cone crusher

When CS series cone crusher is working, the motor drives the eccentric ring spin through V-belt, big belt wheel, transmission shaft, big bevel gear and small bevel gear. The crushing cone spins by the force of eccentric ring, which makes the crushing wall approach and leave rolling mortar wall to and fro, so the materials get impacted and broken in the crushing chamber formed by fixed cone and movable cone. The materials were discharged from the bottom after several times` break until they get the required grade.

Plastic Injection Clear Housing

The transparency of the plastic injection transparent shell matrix resin itself has a great influence on the transparency of PP plastic products. In order to improve PP transparency, a small amount of polyacrylate resin with good transparency and compatibility can be added.

(1) the inorganic nucleating agent mainly consists of ultra-fine talc powder and SiO2, and also includes calcium carbonate, mica powder, inorganic pigments and fillers, etc., which is cheap in price and rich in source, but has certain influence on the gloss and transparency of the products.

(2) organic nucleating agent organic nucleating agent is a kind of organics with low relative molecular weight, represented by sorbitol and its derivatives. It has good compatibility with matrix resin and can significantly improve product transparency and surface gloss.

(3) in the case of sorbitol, when the amount of nucleating agent exceeds 0.3%, the effect of transparency improvement is not obvious, and even decreases. However, when the dosage is less than 0.2%, the nucleation quantity is insufficient and the transparency is not increased enough. It can be seen that the amount of nucleating agent should be between 0.2-0.3%. Therefore, suitable nucleating agent content can better improve the transparency of PP.

Plastic Injection Clear Housing,Injection Molded Transparent Shell,Injection Molded Transparent Shell Proofing,Transparent Plastic Housing,Clear Plastic Housing

Timeplex Industrial Limited , https://www.catimeplexhk.com